Transverse frames are more widely spaced on a ship that is designed with the __________.
In longitudinally framed double bottoms, solid plate floors are fitted at _________ frame space in pounding region and at ________frame space under the main engine.
Which of the following must be provided in a shaft tunnel?
Which of the following takes the weight of the rudder?
In- water survey in lieu of a one of the two docking surveys in a 5-year period may be accepted when:
Items no. 1 shown in figure above is
Panting arrangements are usually fitted up to __________ percent of ships length abaft the stem.
The welded joint located between two plates in the same strake of hull plating is called as
The lower and the upper stools are provided for bulk carriers
Reserve buoyancy is more in
In ship beam bracket are triangular plates joining the deck beam to a.
The bleeder plug or docking plug located on a motor vessel double bottom tank is used to
A collision bulkhead must be fitted to all ships at _________________ of ships length abaft the stem at the load water line.
Stability of a vessel is defined as:
What is the Fresh Water Allowance?
Pitch of propeller is defined as
What is “POSITION 1” according to the LOAD LINE RULE?
In transversely framed double bottoms, the maximum spacing between solid floors should not exceed ______________ in any region.
Why TPC is not constant for ship like structure along the draft?
A Suezmax vessel will have the following maximum limitations:
Air pipes in tanks are generally located:
Apparent slip is defined as
Which of the following pre-painting surface preparation methods is considered most efficient in case of hulls of modern day ships?
In longitudinally framed double bottoms, the maximum spacing between solid floors should not exceed ______________ in any region.
The cyclic angular motion of a ship about the ford? Aft axis under the action of waves is known as:
Which of the following statements is true?
KG of ship increases with (add option B if MCQ)
Peak tanks are tested by:
Plates used to connect stern frames to flat plate keel are called:
Which of the following types of tanks can aid in improving the draught without considerably altering the trim?
Vertical support member used to strengthen bulkheads are called
The primary purpose of fitting a bulbous bow is to:
The most common option for propulsion for a medium to large size merchant ship is a:
_______ Transverse Watertight Cargo Hold Bulkhead____________ Type of Collision Bulkhead.
What is the purpose of cant frames in steel vessels?
What is The Effect on RESERVE BUOYANCY when the ship is in Fresh Water (for same Displacement)?
Hatch Coaming Minimum height? (450 mm if from superstructure)
Which of the following types of ships are assigned minimum freeboard?
Position of centre of buoyancy for box shaped barge
Identify part no. 6 in the given figure:
At the ends of the ships, to prevent making plates too narrow, pairs of adjacent strakes are made to run into one strake with the help of:
The mass of a ship without cargo, fuel, stores, water, crew etc that a ship carries is known as:
Deep tanks are tested by:
as per the condition of assignment of port holes. no of porholes are allowed to be fitted below_______% of the ships_________or__________mm.
The edge of the propeller which cuts the water first, when the ship is driven ahead is known as ______________
Water survey is done on __________
Thickness of strakes of bottom plating is increased in which of the following regions of the ship?
When the frictional resistance increases when the draft increases?
Block coefficient of crude oil carrier is between
The purpose of providing camber is to: